Accusil Light Body

  1. Home
  2. Impression Materials
  3. Accusil Light Body

Accusil Light Body

Hydrophilic Vinyl Polysiloxane Impression Material - Light Body
  • Additional silicon based impression material in a convenient automix delivery
  • Excellent hydrophillic properties
  • Provide extra smooth & highly precession impression
  • Wash material for putty-wash impression technique
  • Excellent reproduction of marginal contours


  • 2 x 50ml Base/Catalyst Paste, 10 x Mixing Tips- Yellow, 1 x Instruction Manual.



The product has been extensively tested and approved by the Food and Drug Administration, USA
CDSCO Registered
Registered & Approved as per MDR 2017 Guidelines by Central Drugs Standard Control Organization
The product is audited & approved as per CE standards and laws, and has a valid CE Certifications
light body impression material
light body impression material


  • Wash material for the putty-wash impression technique.
  • Syringe material for the simultaneous mixing technique.
  • Impression material for relining.
  • Cavity impression of facing, inlay, onlay etc
  • Impression of crown or bridge, partial or full denture


  • Excellent reproduction of marginal contours
  • Excellent flow properties
  • Excellent wettability
  • Ideal working time
  • Optimal intra-oral setting time
  • Good tear strength and dimensional stability
  • Compatible with all putty based VPS products.
Technical Data Standard Applied
1. Setting Time 4:30 min. ISO 4823
2. Shore Hardness
After 6 min.
65 Min.


There are no reviews yet.

Be the first to review “Accusil Light Body”

Your email address will not be published. Required fields are marked *

Instructions for use :

Pull off the cartridge plug and discard it. Eject a small amount of material directly out of the cartridge onto a paper towel/tissue held in your hand. Extrude enough material until it is evident that base and catalyst are being ejected. This ensures proper mixing. Immediately wipe the cartridge orifice to remove excess material. Attach the mixing tip to the cartridge by aligning the prongs inside the tip with the cartridge orifice. Seat the tip onto the cartridge and twist a ¼ turn clock-wise (90°) to lock it in place. Push the Oral tip if needed firmly onto the end of the mixing tip. Squeeze the trigger with a smooth, steady force to mix and dispense material. Avoid abrupt movements. Release the trigger to stop the flow.

Impression :

Insert the tray and press it into position (2–3 sec). Hold it without pressure until material is set. Double arch impression technique: after the introduction of the tray, central occlusion must be achieved and maintained until the material has completely set. Material residue needs considerably more time to set at room temperature. Check intraorally if the material is set before removing from the mouth. High temperatures accelerate and low temperatures slow down setting.

Fabrication of models :

The stone models may be poured after 30 min at the earliest. The impression remains dimensionally stable for a practically unlimited period of time (at least 7 days). The surface tension will be reduced and pouring will be facilitated if the impression is briefly washed out with a detergent and rinsed thoroughly in clear water afterwards.

Contraindications :

The use of Accusil Light Body is contraindicated if the patient in known to be allergic to any of its ingredients.

Storage :

Keep away from direct heat. Keep in a cool place

Shelf Life : 3 years from the date of manufacturing

Quick Cart

Add a product in cart to see here!