- Type 2 restorative GIC in prefilled capsules
- Restoration of primary & permanent teeth
- Sustained fluoride release & high compressive strength
PACKAGING
- 10 x Single Shade Capsules, 1 x Instruction Manual.
CE 0123
The product is audited & approved as per European standards and laws, and has a valid CE Certifications
MDSAP
MDSAP quality management system satisfies the regulatory jurisdictions requirements of MDSAP Countries.
CDSCO
Registered & Approved as per MDR 2017 Guidelines by Central Drugs Standard Control Organization
US FDA
The product has been extensively tested and approved by the Food and Drug Administration, USA
INDICATIONS
- Restoration of primary teeth
- Core build up
- Restoration of class III, V and Limited class I cavities
PRODUCT BENEFITS
- Optimised powder/ liquid ratio
- High wear resistance
- Simple to place, and easy to handle
- Self- curing/self adherent
- Radiopaque and offers strong adhesion to enamel and dentine
- High and sustained fluoride release
- Coefficient of expansion similar to tooth structure
| Technical Data | Standard Applied | |
|---|---|---|
| 1. Mixing Time | 10 Sec. | ISO 9917-1 |
| 2. Setting Time | 2 – 2.20 min. | |
| 3. Compressive Strength | 130 – 140 MPa. |
Size10 Capsules
Instructions for use :
- Prepare tooth using standard techniques. Extensive mechanical retention is not necessary.
- Wash and dry but do not dessicate. Micron Dentin Conditioner is recommended to remove the smear layer.
- Tap the capsule on a hard surface to loosen the powder.
- To activate the capsule push the plunger onto a stable surface until it flushes with the body of the capsule.
- Immediately place the activated capsule in a capsule mixer (2900-3000 oscillations/ minute) and mix for 10 seconds.
- Immediately remove the mixed capsule from the mixer and attach the applicator nozzle before loading onto the Capsule Applier.
- Click the trigger of the applier until glass ionomer paste is seen through the clear nozzle.
- Extrude cement into the cavity, being careful not to trap air under the restoration. Higher temperatures will shorten working time.
- Form the contour.
- Working time is 1:30 minutes from the start of mixing at 23°C (73.4°F). Net Setting time is 2:00 to 2:20 minutes.
Warning : Avoid prolonged or repeated contact with skin (allergic contact dermatitis), and eyes. Avoid prolonged inhalation. Do not take internally Contact with the skin may cause irritation and hypersensitivity. If contact with skin occurs immediately wipe off thoroughly with cotton and alcohol and then wash well with soap and water. If skin rash and sensitization or other allergic reaction occurs discontinue use and seek medical attention. If the product comes into contact with the eyes, rinse thoroughly with fresh water and consult a physician. It should not be used with patients who have a history of severe allergic reaction to any of the components.
Precaution : In case of contact with oral tissues or skin, remove immediately with a sponge or cotton soaked in alcohol Flush with water. In case of contact with eyes, flush immediately with water and seek medical advice.
Contraindications :
- Pulp Capping
- In rare cases, the product may cause sensitivity to some persons. If such reactions are experienced, discontinue the use of the product and refer to a physician.
Storage Conditions : Store at temperature between 10°C to 24°C. Close the cap carefully after use. Keep away from moisture. Shelf life is not affected after opening if stored in a cool dry place.
Shelf Life : 3 years from the date of manufacturing.
Reviews
There are no reviews yet.