- Thermoplastic Impression material for primary impression in denture cases
- Easy to warm up & quick hardening in cold water
- Excellent compatibility with hydrocolloid or silicone material
PACKAGING
- 5 round plates / cakes, Net wt : 200 g.
CDSCO
Registered & Approved as per MDR 2017 Guidelines by Central Drugs Standard Control Organization
CE
The product is audited & approved as per CE standards and laws, and has a valid CE Certifications
INDICATIONS
- Correction models.
- Raising the edges of the impression.
- For primary impression in edentulous cases before preparing special tray.
PRODUCT BENEFITS
- Easy to adjust
- Alteration to impression can be made easily to achieve accurate impression
- Excellent compatibility with most hydro-colloid or silicone materials
SizePack of 5
Instructions for Use :
Immerse the required quantity of Hiflex Impression Composition in hot water (55°C / 132 °F). When softened knead thoroughly with the fingers and place in a dry impression tray. Before inserting in the mouth, pour a little cold water over the back of the impression tray. Glaze the surface with dry heat (over a spirit lamp or Bunsen), being careful not to use too much heat, and quickly insert into the mouth. After removal, put in to cold water.
Precautions :
- Personal protective equipment (PPE) such as gloves, face masks an safety eyewear should always be worn.
- In case of contact with eyes, remove and wash with water.
- In rare cases the products may cause sensitivity in some people. If any such reactions are experienced, discontinue the use of the product and refer to a physician.
Storage Conditions : Store at temperature between 10°C to 24°C. Close the cap carefully after use. Keep away from moisture. Shelf life is not affected after opening if stored in a cool dry place.
Shelf Life : 3 years under proper storage.
Reviews
There are no reviews yet.